Introduction of Sincecam steering Arms
SC25T01 is made of all-aluminum CNC, and the middle of the arm body is hollowed out, so that the hardness of the arm body of SC25T01 is weakened. The purpose is to protect the steering gear. If you get out of danger, the high-torque steering gear will twist and deform the rocker arm, rather than the steering gear breaking the drive shaft or the gear is damaged.
SC25T02 is CNC-molded with soft aluminum material, and the arm body is thickened as a whole. However, due to the insufficient hardness of the aluminum material, when the wheel of the remote control car is stuck and cannot swing or falls from a high altitude, the torque of the steering gear will make the rocker arm and The spline tooth of the arm at the connection of the steering gear drive shaft is worn out, so as to protect the steering gear.